April_AMP_Digital

A D V A N C E D M A T E R I A L S & P R O C E S S E S | A P R I L 2 0 1 8 2 7 there is no change in yield stress after annealing at 950 o C (0.9 T m for Cu). The PDC-MMC process enables production of highly creep-resistant metal alloys. MELT-INJECTION ROUTE The melting point of magnesium (650 o C) is below the temperature where the polymer converts into the ceram- ic phase, thereby enabling injecting the polymer directly into the melt and having it convert into the ceramic while surrounded by the metal. Two ways to introduce the polymer are by cross-link- ing it, milling it into a powder (as in the approach with Cu), and then, by inject- ing it directly as a liquid into the mag- nesiummelt. The polymer was injected into the magnesium melt by the stir casting method [14,15] . Highly wetting behavior of the polymer enabled it to be drawn spontaneously into the melt. Type B1 polymer powder (5 wt%) was added into the melt at 730 o C and stirred for 15 minutes. The melt was cooled to 675 o C, and poured into 15- and 25-mm- diameter cast-iron molds. Cast cylin- drical ingots were heat treated at 400 o C for one hour and extruded down to a ra- tio of 9:1. Microstructures of the as-cast and extruded samples are shown in Fig. 2. Raman spectra from the ceram- ic-particle region in the cast structure are a simple way to determine that the organic precursor has fully converted into the ceramic phase. The microstructure of the casting (Fig. 2a) shows that the SiCN ceramic particles segregated toward the grain boundary regions, which break down into nanoscale particles (Fig. 2b) af- ter extrusion; interparticle spacing, λ is about 1 µm [15] , which from Equation 1 is expected to produce only a modest improvement in mechanical properties. Nevertheless, the strain rate (Fig. 2d) measured in compression at 450 o C, is reduced by a factor of ~5 by the ceram- ic particles. Also, creep resistance does not degrade with time, confirming the particles do not coarsen. Melt injection experiments were also carried out within a glovebox to prevent oxidation of magnesium. Cast- ings from a 70 × 20 × 90 mm mold [16] were used directly for mechanical testing without extrusion or further heat treatment. Polymer was insert- ed in the form of cross-linked powder, but also by injecting the liquid direct- ly into the melt [16] . The volume fraction of the ceramic phase was 2.5 vol%. Flat dog-bone shaped specimens were ma- chined from the castings for mechanical testing at ambient and high tempera- tures (350 o to 450 o C). Creep testing was also performed. Pure Mg castings were also made for comparison. Results from tensile tests at am- bient temperature are shown in Fig. 3. Yield strength increases from 10 MPa for pure Mg to 80 MPa for the castings made with PDCs. Ultimate tensile stress increases from 70 MPa for pure Mg to 130-150 MPa for 2.5% PDC strength- ened samples. Tensile ductility is not significantly affected by the addition

RkJQdWJsaXNoZXIy MjA4MTAy