August_EDFA_Digital

edfas.org 31 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 3 electrical testing. Figures 15 and 16 show the analysis conducted on a process control monitor structure with Fig. 17 SEM top-down image (top le«) of the process monitor structure and FIB cross-section SEM images of the RCI site from Figs. 15 and 16 illustrating varying degrees of microcracks at the substrate layer belowmetal 1. Microcracks a’ect the active (AA), PC gate (PO), interlevel dielectric (ILD), and shallow trench isolation (STI) material. Fig. 15 Test structure composed of metal 1 contact chain to active regions with dummy metal 1 line parallel to the chain. RCI image was scanned at 2 kV and 26 nA of beam current. Fig. 16 SEM/RCI overlay imagehighlighting the localized site. Fig. 18 Contact/active (CA/RX-AA) resistive open failure on health of line (HOL) test structure consisting of a single metal 1/contact (CA) chain to islands of active (RX-AA) regions with parallel polysilicon (PC) lines. The RCI result, recorded at 2 kV/1.6 nA, localizes the defect site on the M1/CA/PC/RX test structure. long single metal 1 (M1) contact (CA) chain to active (RX) regions with dummy metal 1 lines perpendicular to the chain. The wafer was failing for “high resistive” open. The RCI data recorded at 2 kV/26 nA allowed localization of the defect site to a single M1 site. FIB cross-sections of the EBAC/RCI site showed mul- tiplemicrocracks belowmetal 1 (Fig. 17). Themicrocracks severed the PC (PO), RX (AA), and the shallow trench iso- lation (STI) below metal 1. This resulted in the observed high resistive open. CASE #6: FEOL MICRO CONTAMINATIONS AHOLwafer failing for CA/RX high resistive “open”was analyzed. Figures 18 and 19 illustrate the failure analy- sis performed on a test structure consisting of a single

RkJQdWJsaXNoZXIy MjA4MTAy