August_EDFA_Digital

edfas.org 19 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 3 EXPERIMENTAL SYSTEM Figure 2 shows a schematic diagramof the experimen- tal system. The transducer, driven by a signal generator with a burst signal, generates an ultrasonic wave for stimulation. The signal generator provides the refer- ence signal for the lock-in detection as well. Only 40 and 80 MHz transducers are employed in this research. The transducer and sample are acoustically coupled using water droplets as a medium. A voltage is biased to the sample. The current amplifier measures the current change in thewiring due to the ultrasonic stimulation, and this change is detected by the lock-in amplifier. Because the output of the lock-in amplifier depends on lateral positioning, a 2D profile of the localized failure is created by scanning the transducer along the x and y axes. An ultrasonic reflection image is acquired prior to this step. BASIC DETECTION METHODOLOGY EXPERIMENT ON A WIRING SAMPLE WITHOUT MOLD RESIN The test sample is a chipwith varying aluminumwiring widths of 0.6, 1, 2, 4, and 8 µm. Length is 500 µm. Figures 3a and 3c show the laser and ultrasonic reflection images respectively. IR-OBIRCH was acquired using a 1.3 µm wavelength laser. The transducer frequency and lock-in modulation frequency for SOBIRCH was 80 MHz and 1 kHz, respectively. The bias conditionwas 500mV in both experiments. Figures 3b and 3d show measurement images by IR-OBIRCH and SOBIRCH methods at 2 µm wiring width. It is evident that both methods could detect the signal from the 2 µm wide wiring. EXPERIMENT ON A WIRING SAMPLE WITH MOLD RESIN Another wiring sample, sealed with mold resin, was subjected to SOBIRCH inspection. Figure 4 shows a diagram of the sample structure. The sealant is an epoxy resin comprised of a filler with an average particle size of 16 µm in diameter. Multiple samples with varying resin thickness of 305, 320, 420, 620, and 1000 µm directly on top of the chip were studied. Figure 5 shows images where the wiring width and resin thickness were 2 µm and 305 µm, respectively. Fig. 4 Structure of wiring sample with mold resin. Fig. 3 IR-OBIRCHandSOBIRCH images of 2µmwiringwidth. (a) (b) (c) (d) Fig. 5 SOBIRCH imagewith 305 µmmold resin using 40 and 80 MHz transducers. (a) (b) (c) (d)

RkJQdWJsaXNoZXIy MjA4MTAy