August_EDFA_Digital
edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 3 18 ULTRASONIC BEAM INDUCED RESISTANCE CHANGE Toru Matsumoto Hamamatsu Photonics K.K., Hamamatsu, Japan toru@sys.hpk.co.jp EDFAAO (2018) 3:18-22 1537-0755/$19.00 ©ASM International ® INTRODUCTION Photon emission microscopy (PEM) is a powerful tool used to locate failures in semiconductor devices by detect- ing light emissions. However, detection is not possible if the device is embedded inside the package. Therefore, the mold packagemust be removed before performing detec- tion. Although lock-in thermography (LIT) can detect the signal propagating through the package mold, the signal spreads under the influence of thermal diusion through the mold resin and makes failure point identification dif- ficult. Infrared optical beam induced resistance change (IR-OBIRCH) detects the resistance change that takes place when the substrate with biased wiring is stimulated by an infrared laser beam. It is used to find leakage current paths and contact area failures in semiconductor de- vices. [1] However, this technique requires mold decap- sulation because the infrared laser does not propagate through a packagemold that is optically nontransparent. Ultrasound, generally defined as sound waves higher than 20 kHz, is widely used in medical and industrial inspections. In the field of semi- conductor devices, ultrasound is o¨en used to detect detachments and cracks in semiconductor pack- ages. [2,3] Researchers have developed a new technique for package failure analysis on wiring defects using ultrasound without mold decap- sulation. The wiring in the chip within the package is stimulated by ultrasound. The role of ultra- sound is similar to the infrared laser beam in IR-OBIRCH, as they both provide a heating eect. However, the ultrasonic beam induced resistance change (SOBIRCH) method does not require mold decapsulation because ultrasound can propagate through a package mold that is acoustically transparent. The resistance change that occurs as a result of the heating eect is subsequently detected by an amplifier. Figure 1 shows the comparison between IR-OBIRCH and SOBIRCH. Fig. 1 Comparison of IR-OBIRCH and SOBIRCH. Fig. 2 Schematic diagram of experimental system.
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy