August_EDFA_Digital

edfas.org 1 1 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 3 Corresponding pessimistic arguments are as follows: • Fewer counterfeit parts are being detected because quality is outpacing detection methods. • Fewer counterfeit parts are being reported. The recent downward trend is likely due to a combina- tion of these reasons. No doubt, distributors, contractors, and government organizations are more aware of the counterfeit risk in recent years and many organizations have enacted new, robust processes aimed at keeping counterfeit parts from being purchased. Supplier audits and assessments, proactive obsolescence management, and decreased reliance on the unauthorized supply chain (or gray market) have certainly reduced the opportunity for an organization to buy a counterfeit electronic part. In addition, lawenforcement personnel are continuing their eƒorts to seize counterfeit parts at border entry points. Conversely, it is also assumed that counterfeiters are finding betters ways to remove markings, apply coat- ings, remark parts, replate leads, and disguise other part variations that would be red flags for personnel performing authentication work. While the trend since 2015 is encouraging, it should be taken with a grain of salt. Counterfeit electronic parts should be presumed to be an ongoing challenge for the foreseeable future. Note, recent data through May 2018 shows the trend leveling oƒ or rising again. POPULAR COUNTERFEIT PARTS Integrated circuits, or ICs, have been the most com- monly counterfeited electronic part as far back as data exists. In fact, ICs have comprised 85 percent of all coun- terfeit electronic parts every year from2012 through 2016. The remaining most-counterfeited electronic part types include transistors, diodes, and capacitors, in this order. The data shows that all types of integrated circuits are susceptible to counterfeiting, fromcomplex parts such as microprocessors and field programmable gate arrays (FPGAs) to basic building blocks such as digital gates and operational amplifiers. However, it appears that themore complex IC types aremore attractive to counterfeiters. For 2017, as inprevious years, over 60percent of suspect coun- terfeit ICs fall into three categories—microprocessors/ microcontrollers, memory, and complex programmable logic devices (including FPGAs). Figure 2 shows the breakout by IC part type, with these three categories comprising 62 percent of the reported ICs. This should not be particularly surprising, as these are the Fig. 1 ERAI monthly reports, counterfeit and high-risk parts. Fig. 2 Suspect counterfeit percentage by integrated circuit type, 2017. Number of reports

RkJQdWJsaXNoZXIy MjA4MTAy