May_EDFA_Digital

edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 6 soft, powdery dust layer. In this form, a failure is unlikely because the amount of precipitated phosphorous at the contact point itself is even less than on the outer regions of the contact surface. However, phosphorous acid (H 3 PO 3 )—and even more so, phosphorous oxide (P 4 O 10 )—are hygroscopic. In fact, phosphorous oxide is used as a desiccant. This means it attracts and holds relatively large amounts of water from the atmosphere, forming an aqueous solution. Only a moderate amount of relative humidity is required to create this effect. This leads to a contact surface that is covered with myriads of small liquid droplets. The shock of switching the contacts lets them coalesce. As a result, the complete contacts are covered with a layer of a liquid—a saturated phosphoric acid solution. Aswe learnedwith oily surfaces, this liquid also flows into the capillary between the closed contacts. Once the contacts have separated, a large drop of the liquid is left at each contact point. As the humidity decreases, a dense layer of solid phosphorous oxide and acid at both contact points may be observed. Contact failures can occur if this layer is thick enough (Fig. 3,4). This is yet another self-centering failure mechanism. The hygroscopy of the precipitation can be used to make a quick test for phosphorous. When you blow onto the contacts, the moisture in your breath will create a droplet around every white crystal (Fig. 5). A short time later, the liquid dries and transforms back into a small white crystal. The probability that these precipitations are phosphorous compounds is very high, because other white powdery dust—which is sometimes found inside plastic housings, such as adipic acid from decomposing polyamide—is not hygroscopic. Fig. 3 (a) Phosphine is excreted on the contact surface and oxidizes to hygroscopic phosphorous oxide and phosphorous acid. (b) Depending on relative humidity, droplets of wet phosphoric acid form. (c) Fluid gathers in the capillary around contact points. (d)Whencontacts open, two largedrops remainat the contact points. If they dry out (e), the concentrated excretion can cause contact failures (f). Fig. 4 Top: SEM image of a typical contact surfacemanifest­ ing phosphorous excretion resulting in contact fail­ ure. Bottom: Optical microscope, polarized light, dendrites crystallized from concentrated phospho- ric acid.

RkJQdWJsaXNoZXIy MjA4MTAy