May_EDFA_Digital

edfas.org 7 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 Such failures can also occur on sealed relays. Particularly large relays tend to pop during soldering because the trapped air expands and the bonding cracks open. The contacts next to the crack in the glue are vul- nerable to failures caused by phosphorous deposition. WAX ON CONTACTS OF MINIATURE CONTACTORS/RELAYS Wax is another substance that may cause failures in relays or miniature contactors. It is often used as a glide agent onenameled copperwires toachieveperfectwound coils. Wax adheres to the wire until the coil is heated, causing it to evaporate. Subsequently, the complete inner surface of the relay or miniature contactor involved is covered with a thin film of liquid wax. Solidifying wax in capillaries between moving parts can act like a hotmelt adhesive and mechanically inhibit switching. Frequently, another self-centering failure mechanism occurs as more and more wax collects on the coldest parts in the relay, which are the contacts. In operation, the relay is hot, i.e., the wax is liquid and as long as it remains liquid on the contacts, no problems occur. However, once the relay cools down after operation, the drops of wax harden; these are the drops that converge at the contact points every time the contacts open. If the wax is very hard, the contact pressure is not sufficient to penetrate the wax deposit. In low temperature environments, such as a parking garage on awintermorning, this can lead to a contact failure andan elevatormay not respond. When the technician arrives two hours later, the elevator operates perfectly—until the next cold morning (Fig. 6). Such faultsmainly occur with small contactors, which have a similar design to relays, but inwhich larger quanti- ties of enameled copper wire are processed. The contact force of bigger contactors is usually high enough to avoid contact problems. SUMMARY Based on many case studies, complicated interrela- tionships that appear when analyzing the contact failure of a mechanical relay have been observed. Particles and fibers are often the immediate concern. However, it is usually the complicated physical/chemical interactions inwhich phase transitions occur between gaseous, liquid, and solid forms of a material—such as wax —that create problems on a more frequent basis. The influence of Fig. 5 With humidity, small droplets form on the phos­ phorous excretion, e.g., when someone blows onto the contacts. Fig. 6 Contacts of a control relay that have failed due to wax accumulation at the contact points. Design: (a) One large contact. (b) Two separate small contacts with contact edges, usually duplicated, as contactors use bridges with two contacts; shown here are two parallel double bridges. Liquid wax flows into capillaries between contacts and causes failures after cooling as the wax drops solidify directly on contact points. The theoretical advantage of double contacts with regard to contact reliability regarding particles, e.g., dust, does not apply to vapors. Enameled copper wires with wax-free glide agents must be used. (a) (b)

RkJQdWJsaXNoZXIy MjA4MTAy