May_EDFA_Digital

edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 20 transistors switching at a given frequency. It is convenient to run the DUT’s clock and data at different frequencies, so that both signal paths can be individually and simul- taneously mapped. The unique ability to map periodic signals in a DUTmakes LVI well suited for scan chain diagnosis because the data propagation through the scan chain is clocked with a periodic signal. The LVI map can easily identify the broken point for a scan chain failure, whether the defect is in the data signal path or in the clock signal path. LVP enables acquisition of awaveform in the time domain at a specific physical location. For example, waveformsmay be obtained at the broken scan chain location identified with LVI. Through layout tracing andwaveformcomparisonwith a reference sample, the fault location may be narrowed down to an inverter or a node. Because the scan chain concept has been incorporated into SRAM design, scan chain failures are additional failure modes in SRAM, and these require fault isolation prior to PFA. For such failures, LVI/LVP is the primary choice of diagnostic techniques. DIAGNOSTIC TECHNIQUE SELECTION: CASE STUDIES The features of each diagnostic technique determine its application. PEMandTIVA/OBIRCHare suitable for hard failures. PEM analysis is often performed first because its setup is simpler than that of TIVA/OBIRCH. As PEM and TIVA/OBIRCHare sensitive todifferent defect types, when- ever PEM analysis fails to detect an abnormal emission site, TIVA/OBIRCH analysis is attempted. For soft failures, CPA is naturally the right choice, as it captures the change between pass and fail status caused by laser stimula- tion. LVI/LVP is the primary choice for SRAM scan chain failures because it has the unique capability of mapping the periodic signal in a DUT. In this section, four cases of SRAM logic type failures analyzed with the appropriate diagnostic techniques are presented. CASE #1: PEM ANALYSIS FOR A BLOCK FAILURE The first case study is a block 512BLX128WL failure for an 8Mbit SRAM. Figure 5 shows the failure bitmap of two segments (1Mbit per segment) of the8Mbit SRAM. Thedark rectangular shape represents the block 512BLX128WL failure. First, static PEM analysis through backside silicon was performed. It failed to detect any abnormal emission site because static power-up couldnot exercise the failure. So dynamic PEM analysis, running a repeating functional Fig. 4 Diagram of an LVI/LVP setup. Fig. 5 Failure bitmap showing a block 512BLX128WL failure in an 8Mbit SRAM. Fig. 6 PEManalysis image showinganemissionsiteatword- line driver area for the block 512BLX128WL failure. Fig. 7 SEM image showing a poly micro-mask, causing a poly-contact short.

RkJQdWJsaXNoZXIy MjA4MTAy