May_EDFA_Digital
edfas.org 21 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 test pattern, was performed. An emission site associated with the block failurewas detected at theword line driver area, as shown in Fig. 6 (20 × at left and 50 × at right). After the failing area was located, the sample was subjected to layer-by-layer deprocessing and SEM inspections. At the polysilicon gate level, the SEM inspection found a poly micro-mask defect, causing a poly-contact short at the emission site as shown in Fig. 7. The defect forced the transistor into saturation, leading to photon emission. CASE #2: TIVA ANALYSIS FOR A BLOCK FAILURE Another 8Mbit SRAM chip suffered from a block 128BLX128WL failure. Fig. 8 shows a two-segment failure bitmap, where the dark square shape represents the block 128BLX128WL failure in a 1Mbit segment. Again, first backside PEM analysis was performed. Neither static nor dynamic PEManalysis coulddetect abnormal emission on the failing segment when compared to a good segment. Then, backside TIVA analysis with 1340 nm laser stimu- lation was performed. Figure 9 shows the TIVA analysis image (10 × on top, 100 × on bottom). It is clear that an abnormal signal is present at the word line rebuffer area correlating to the block 128BLX128WL failure. Based on the TIVA analysis result, follow-up physical analysis was performed. At metal 1 (M1) level, SEM inspection found a metallic particle bridging two M1 lines, as shown in the SEM backscattered electron (BSE) image in Fig. 10. Because the defect in the BEOL caused an ohmic short, it is reasonable that neither static nor dynamic PEManalysis detected any abnormal emission. Instead, the TIVA tech- nique was successful in localizing the defect. When the 1340-nm laser illuminated the defect, the thermal effect caused a large change in its resistance, enabling TIVA to capture the location. CASE #3: CPA ANALYSIS FOR A SOFT BLOCK FAILURE The third case study is a soft block failure. A block 192BLX512WL in a 48Mbit SRAM failed at lowvoltage only, as shown in Fig. 11. Because this case was a soft failure, CPA was the right choice for its fault isolation. First, a shmoo plot was generated to find the exact V DD voltage where the failure occurred and to identify the pass/fail Fig. 8 Failure bitmap showing a block 128BLX128WL failure in an 8Mbit SRAM. Fig. 9 TIVA analysis image showing response to the laser at the word-line re-buffer area for the block 128BLX128WL failure. Fig. 10 SEM BSE image showing a metallic particle bridging two M1 lines. Fig. 11 Failure bitmap showing a soft block 192BLX512WL failure in a 48Mbit SRAM.
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy