February_EDFA_Digital
edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 6 is nearly impossible. However, if an arc does form, the oil will evaporate, catapulting the contact open. A sizzling sound can be heard, because this effect may be repeated several times. If the particle is located somewhat away from the shortest distance between the contacts, it will not burn or Fig. 6 Contact failure caused by a glass fiber pulled to the contact point Fig. 7 Contact failure caused by plastic particles pulled to the contact point Fig. 5 (a) Particles stick in the oil on the contact surface. (b) Surplus oil flows into the capillary between the contacts. (c) Opening the contacts pulls the surface of the oil and the particles to the center of the contact. (d) Particles can cause contact failures. sink into themolten contact surface. The arc can continue to burn for a long time. If direct current is involved, then material can also be transported, forming a tip and a hole. The failure manifests itself in such a way that a higher contact resistance is measured (Fig. 8, 9). SILICONE OIL OR SILICONE VAPOR IN AN ELECTRIC ARC IS TRANSFORMED INTO SILICON DIOXIDE Contact failure is not caused just by solid particles. If electric arcs occur and silicone oil or silicone vapor is present, the silicone is oxidized to silicon dioxide (SiO 2 ), in the solid formcommonly known as quartz or glass. This nonconductive silicon dioxide condenses as an insulating layer in just the contact region. The process is again self- centering because the highest fields occur at the shortest distance, which is the contact region (Fig. 10). Part II of this article, which will appear in the May issue of EDFA , will discuss the formation of nitrous gases caused by arcing and the formation of phosphoric acid crystals on contacts, resulting from the addition of red phosphorus as a flame retardant to certain plasticmateri- als. It also will discuss why sealed relays, which pop open during soldering, are prone toprecisely this type of failure. Finally, a failuremechanismdue towax, which is used as a lubricant for the enameled copper wire of the relay coils, will be discussed.
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy