February_EDFA_Digital
edfas.org 5 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 CONTACT FAILURE CAUSED BY NONCONDUCTIVE PARTICLES AND FILMS BETWEEN THE CONTACTS Themost common failure type for an electromechani- cal relay is a nonconductive particle lodged between two switching contacts. Frequently, the particle is a chip from a plastic part. Particles are also formed if metal parts scrape against plastic surfaces. This results in oxidized metal wear as well as plastic wear (Fig. 2a,c,d) and glass fiber fragments from the glass-fiber-reinforced plastic (Fig. 3, 4). Further, solid flux residues from soldering the copper wires of the coil to the pins can be found on the contacts (Fig. 2b). It has been observed that nonconductive particles between two contacts do not appear by chance, but this is a self-centering failure mechanism. The mechanical shock caused when two relay con- tacts open causes particles in the relay to bounce. An inhomogeneous electrical field is simultaneously built up, which exerts a force on the particles. They are pulled in the direction of the force. It may take tens of thousands of switching operations, but, at some point, the particle finally reaches the center of the force. A very thin film of oil is often used in relays to prevent this type of failure. These particles adhere to this thin film of oil and do not move, due to inhomogeneous electrical fields. CONTACT FAILURE CAUSED BY CONTACT OIL If contact oil is used in electromechanical relays, the type of oil used and the quantity applied are very important factors. Perfluoroether is common and a good choice; however, the quantity is critical. If the oil is applied undiluted in a layer more than a few micrometers thick, then another self-centered failure mechanism can occur. Particles stick on the oily surface (Fig. 5a). If the oil film is too thick, it acts as a liquid, and the fluid coalesces in the capillary around the contact point (Fig. 5b). When the contacts separate, the surface of the oil is pulled into the direction of the contact point, as are the particles that have attached themselves to the fluid (Fig. 5c). After a number of switching operations, the particle reaches the contact point (Fig. 5d) and causes the failure. Figures 6 and 7 showexamples of a glass fiber and a plastic particle that have been pulled to the contact point. ELECTRICAL ARCING DUE TO LARGE PARTICLES BETWEEN THE CONTACTS If a large particle prevents the contacts from being tightly closed, an electrical arc may build up, depending on the diameter of the particle and the applied voltage. In air, there is a basic rule that an electric field of 1000 Volts/mmdistance (1 V/µm) is required for an electric arc. This means that 24 V can arc over a distance of 24 µm. Oil between the contacts usually overrides this rule. An arc Fig. 3 Glass fibers (with and without plastic residues) on the relay contacts Fig. 4 A glass fiber caused arcing between two relay contacts. The fiber is outside the region of the shortest distance between the contacts, so it does not sink into the molten silver surface. The current is alternating, so the arc is not stationary but moves around. The contact resistance is high because there is no physical contact between the silver contacts.
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy