February_EDFA_Digital

edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 16 size of 10 nm takes approximately 7 min. Figure 8 shows a grain orientation map acquired with this technique on a good and a bad NMOS memory bitcell in a 28 nm fully depleted silicon-on-insulator (FD-SOI) technology. Several polysilicon grains with multiple orientations are visible on the reference transistor, whereas only one major big monograin (colored blue and green) is observed on the bad NMOS. FAILURE ROOT CAUSE Obviously, control of the grain size during the polysili- con gate process is one of the key factors to reducing the occurrence of this failure. However, the monograin itself cannot explain the electrical behavior of the failing transis- tors. An energy-dispersive x-ray (EDX) chemical analysis comparison conducted on two NMOS transistors (one is reference, one is fail) of a monograin failure in a memory bitcell permits a deeper explanation of the mechanism and the consequences of the failure. In Fig. 9, the reference transistor shows a good arsenic dopant diffusion along the grain boundaries of the polysilicon toward the TiN surface. On the bad NMOS, no arsenic diffusion is visible through themonosilicon grain, because there are no grain boundaries. The arsenic is blocked at the polysilicon/NiSi interface. This comparative EDX study is still ineffective on PMOS because it is very hard to acquire the boron x-ray signature. The lack of dopants at the poly/TiN interface due to a monograin (no diffusion path) in the polysilicon gate leads to degradation of the transistor electrical dynamic performance. The gate is not more metallic and acts as a semiconductor; this leads to an extra delay due to ex- cessive added capacitance and generates a triggering threshold that acts as a Schottky diode. The observation of missing dopants allowed a technology computer-aided design (TCAD) model to be built based on a Schottky diode on the gate, simulating the electrical behavior of Fig. 9 TEMEDX chemical analysis on anNMOS transistor in a 28 nmmemory bitcell. Arsenic diffusion through grain boundaries is visible on the reference transistor, while it is blocked at the polysilicon/NiSi interface due to the monograin on the bad transistor. Fig. 8 Orientation map acquired using ACOM on a reference and a failing NMOS from a memory bitcell in a 28 nm FD-SOI technology. Multiplepolysilicongrains andorientations are visible on the reference transistor, but only onebigmonograin is observed on the failing MOS.

RkJQdWJsaXNoZXIy MjA4MTAy