May_EDFA_Digital
edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 30 “thick” (e.g., > 100 nm) specimens into the “backside” orientation (i.e., substrate “up”). Subsequent FIB thin- ning from the substrate or backside eliminates curtaining artifacts extending into the substrate, since FIB milling is performed from the substrate side of the specimen. [6,9] In addition, specimens manipulated to these slotted half- grids may be Ar + ion milled. [8] Further, advances in Ar + ion probe sizes and functionality allow lift out specimens to be further ionmilled and thinned evenwhenmanipulated onto thin films. [11] Figure4shows still images fromavideoacquired inreal- time of a lift out sample manipulated to a slotted Cu half- grid. [12] The time stamps inminutes:seconds:milliseconds are inset in the images. The time denoted by 00:00:00 starts just a few seconds after lift out. The probe is raised above the sample surface and the specimen positionwith respect to the probe is assessed by adjusting the light optical microscope focus plane. The probe is rotated to position the specimenon top (at 01:02:33). At this step, the orientation of a tab in the specimen created by an asym- metric FIB undercut is also noted. This tab indicates the “top” of the FIB specimen. Then the grid slot of interest is positioned in the field of view and the probe with speci- men is lowered near the plane of the grid. The grid slot edge is used to spin the specimen noting the tab orienta- tion (at 02:20:65). The grid slot edge is also used to center the specimen on the probe (at 02:32:05). Then the probe is lowered through the slot allowing the specimen to rest flat and adhere across the open grid slot (at 02:40:06) in the desired backside orientation. The specimen may now be FIB thinned as usual, including any low energy polishing steps, avoiding curtaining artifacts. The smooth FIB specimen also adheres to the smooth surface provided by the slotted half-grid via VDW forces. As shown in Fig. 5a, it is possible to FIB mill a specimen adhered to the grid only by VDW forces holding the speci- men in place. It is also possible to Ar + ion mill a specimen on these slotted half-grids with no additional attachment MONOGRAIN DEFECT IN POLYSILICON GATES (continued from page 27) Fig. 4 Still images froma real-time video with time stamps (minutes:seconds:milliseconds) showing lift out andmanipulation onto a slotted Cu half-grid into a backside orientation. [12] Fig. 5 (a) FIB image of FIB milled specimen secured to slotted half-grid via only van der Waals forces. (b) TEM image of FIB specimenmanipulated to slotted half-grid into a backside orientation and then further FIBmilled eliminating curtaining artifacts. (a) (b)
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy