May_EDFA_Digital

edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 14 constructed with NMOS as well. The first two columns contain the schematic and layout of the cell. The last two columns contain the LVP waveform library and the truth table. Note that unlike a regular truth table, this table con- tains an additional column for LVP output. This is because LVP output can contain multiple levels for a single logic output depending on the modulation from a number of transistors under the optical probe. For example, consider the NAND gate. Output Z is sandwiched between two PMOS transistors. The spot size of the laser is big enough to cover both PMOS transistors. Total modulation includes the common drain between transistors, as well as the channel regions, assuming the sources are at constant voltage (VDD). When transistors in parallel are turned on at the same time, the number of gates turned on does not make any difference to the voltage on the drain. Therefore, the electrical logic stage of the output does not change and the voltage on the drains are constant. However, the amount of modulation depends not only on the voltages, but also the number of transistors that are ON within the probe spot. As a result, multiple LVP logic states corresponding to the same elec- trical logic state of the cell can be observed in the output waveform of Fig. 3c. To match the electrical truth table, when both transistors are on, the LVP state is denoted as 1 + , and when only one of the transistors turns on, the LVP state is denoted as 1. The minimum state occurs when neither transistors contribute to the modulation, i.e., when both are OFF. Another interesting observation is that the modula- tion depends on whether the transistor is turned ON or OFF, irrespective of whether the source is connected in series or in parallel to another transistor. While in series, themodulation due to the gate voltage will still affect the LVP signal even though the series transistor is turnedOFF. This is clearer when we consider the 2-input NOR gate. Here, the three LVP states are 1, 0, and 0 - to match the logical truth table. If we compare the waveform libraries of the NOR gate in Fig. 10 with the NAND gate in Fig. 7, they look the same. Asmentioned earlier, themodulation by the gate does not depend onwhether the transistors are in series or in paral- lel. Consequently, the strongest modulation occurs when both transistors are ON, which is denoted as the “1” state. When both transistors are OFF, modulation is theweakest and is denoted a “0 - ” instead of “0.” This helps match the electrical truth table of the NOR gate to the LVP library. A couple of simple 2-input standard cells have been presented here. More complex logic gates can be approached in a similar manner. Knowing which wave- forms to expect from logic gates is extremely beneficial to fault isolation. The following case study showcases the value of employing CLA in conventional fault isolation. CASE STUDY The device under test failed scan logic and the sche- matic, as shown in Fig. 4. Schematic A is comprised of an inverter and a 2-input NAND cell feeding to a 2-input NOR COMBINATIONAL LOGIC ANALYSIS WITH LASER VOLTAGE PROBING (continued from page 12) Fig. 4 Case study highlighting use of CLA. (a) Schematic of failing circuitry. (b) LVP waveforms at the drivers of the inputs and the NOR output indicate no obvious failing signature except the missing third state predicted by CLA. (c) CLA results show logical mismatches between output waveforms collected and the expectations based on the library.

RkJQdWJsaXNoZXIy MjA4MTAy