May_EDFA_Digital
edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 10 COMBINATIONAL LOGIC ANALYSIS WITH LASER VOLTAGE PROBING Venkat Krishnan Ravikumar, Winson Lua, Gopinath Ranganathan, and Angeline Phoa Device Analysis Laboratory, Advanced Micro Devices, Singapore venkat-krishnan.ravikumar@amd.com EDFAAO (2018) 2:10-16 1537-0755/$19.00 ©ASM International ® INTRODUCTION As technologies scale, integrated circuits (ICs) now have incredibly dense transistor packing that can fail due to miniscule defects, which require electrical fault isolation (EFI). [1] Of several available EFI techniques, laser voltage probing (LVP) and derivatives (such as LVx) using continuous-wave near-infrared laser are very popular. [2-5] The operating principle of LVx is that the absorption of light gets modulated by changes in the electrical field and the free carrier (plasma) density within a transistor as it switches. [6] The fault isolation precision of these tools ultimately depends on the resolution of the optical probe. Of the various LVx tools, LVP has the most potential to detect a single electrical toggle within one or a small group of transistors while the IC is in operation. LVPwave- forms are useful in verifying the functionality of individual transistors, identifying broken links in chains, measuring timing delays between circuits, aswell as troubleshooting pattern issues. Versatile as the applications are, inter- preting LVP waveforms is often complicated because the waveforms are created using the interaction of light with a physical area surrounding the transistor of interest. To begin with, the distribution of charges and electric fields within a transistor is nonuniform. The modulation will therefore depend on the field and carrier distribution on each of the nodes (source/drain/gates). In addition, when multiple transistor nodes fall within the optical probe spot, the reflected light is a combination of modulations by each of the additional nodes. When two or more unconnected transistors modulate the LVPwaveform, due to their proximity to eachother and within the probe spot, the signal is a linear superposition of individual waveforms. This is usually referred to as LVP crosstalk. In most cases, this problem can be over- come by changing the test pattern, fine-tuning the probe placement, comparing signals between NMOS and PMOS transistors, and inspecting the inputs and outputs of the transistor of interest. [7] In other words, while the spatial resolution has limitations, the resolution and assessment of toggles occur at different time intervals. Figure 1 is an example of LVP crosstalk. The target tran- sistor is indicated by the red rectangle and the neighbor Fig. 1 Crosstalk occurs (yellow waveform) when two transistors are closer than the optical resolution limit (dotted circles). Careful adjustment of the probe position from the yellow dotted circle to the blue dotted circle helps mitigate crosstalk (blue waveform).
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy