February_EDFA_Digital

edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 22 substrate material, copper pillar and solder heights and diameters, underbumpmetallization, and solder composi- tion (Table 1). FABRICATION OF TEST ASSEMBLIES Copper pillar assemblies were fabricated at Universal Instruments Corporation, which included a 60 × 60 mm interposer substratemetallizedwith a single paddiameter and associatedpadpitch in a pattern that accommodated four similar silicon “chips” (each bumped with copper pillars) (Fig. 2, 3). Copper pillars were dipped in flux and placed on the glass or silicon substrate using an auto- mated pick-and-placemachine. Solderingwas performed in a forced convection reflow oven with a nitrogen atmo- sphere. Peak solder joint temperature during the reflow process was measured on a setup board to be between 240 and 245 ° C, and the time above liquiduswas 64 s. After reflow, all assemblies were inspected electrically using an ohm-meter and through x-ray imaging. (X-ray imaging itself was not sufficient to reveal an acceptable solder joint formation during the assembly process, due to the small size of the joints.) The design allowed the electrical continuity ofmost of the solder joints (including the corner joints) to be continuously monitored during the ATC test. As seen in Fig. 2, the substrateswere designed to be tested in multiples of four testable units. MICROSTRUCTURE CHARACTERIZATION Samples were mounted in epoxy for metallographic sectioning after reflow and after reliability testing. Also, copper pillar samples (chip) and substrate (both glass and silicon) were analyzed. All the samples were ground in a series of steps with abrasive paper, polishing cloths with diamond suspension, and finally with a 0.02 µm colloidal silica suspension. Great care was used with each polish- ing step to remove as much damage as possible from the Table 1 Tests parameters in the current study Parameter Values Interposer substrate material Low-CTE glass (≈3 ppm/K) High-CTE glass (≈8 ppm/K) Silicon Copper pillar and solder cap heights 25 µm Cu + 10 µm solder 15 µm Cu + 20 µm solder 15 µm Cu + 10 µm solder 35 µm Cu + 10 µm solder Solder cap composition Sn, Sn0.9%Ag, Sn1.8%Ag, Sn2.4%Ag Copper pillar pad diameter 30, 50, and 100 µm Metallization layer, component side Nickel, copper Metallization layer, substrate side Electrolytic nickel/gold, copper Fig. 2 Test assemblies were built using the surface-mount technology process, with four similar silicon 12 × 12 mm“chips” (with copper pillars) placed on silicon or glass substrates (60 × 60 mm). Fig. 3 Detail of assembly at the corner of the package (“chip”with copper pillars) fromFig. 2. The design allowed the electrical continuity of most of the solder joints (including the corner joints) to be continuously monitored during the ATC test.

RkJQdWJsaXNoZXIy MjA4MTAy