February_EDFA_Digital
edfas.org ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 18 internal probing (e-beam, time-resolved emission, laser voltage probing). He also supports security evaluations against invasive and semi-invasive side-channel attack (laser fault injection, photoemission, charge and voltage contrast, focused ion beam). His current research focuses on the development of newdefect-localization techniques (three patents granted): dynamic power supply emulation (ESREF 2011), thermal frequency imaging (ESREF and ISTFA 2011), second-harmonic laser voltage imaging (ANADEF 2014, Outstanding Paper at ISTFA 2014), logic-state mapping, and electroluminescence spectroscopy (ISTFA 2015). Laurent Clément obtained a Ph.D. in physics at the Atomic Energy Commissariat in 2006 and an engineer diploma inmaterials science at the Ecole Nationale Supérieure de Physique de Grenoble in 2011. He is currently responsible for the transmission electron microscopy (TEM) imaging group at STMicroelectronics Crolles. Hismission is to support bothmanufacturing and research and develop- ment activities on site through basic and advanced TEM analyses. His team’s current research activi- ties focus on strain, microstructure (using nanobeam electron diffraction and precession electron diffraction techniques), and dopant characterization in next-silicon and SiGe-based device genera- tions (28 nm, 14 nm, and beyond), using STEM/EDS/EELS techniques. He is strongly involved in TEM characterization technique evaluation and development (precession electron diffraction, holography, STEM/EDS/EELS) and in sample-preparation optimization by focused ion beamwith low energy and backside milling. Dr. Clément has co- authored one book chapter, more than ten publications in international scientific journals and conference proceedings, and several oral contributions (two invited talks). ABOUT THE AUTHORS (cont'd) In the November ’17 issue of EDFA magazine, an incor- rect image was inadvertently inserted in Fig. 2 on p. 13 of “Nanoscale Capacitance and Capacitance-Voltage Curves for Advanced Characterization of Electrical Properties of Silicon and GaN Structures Using Scanning Microwave Impedance Microscopy (sMIM)” by Oskar Amster, Stuart Friedman, Yongliang Yang, and Fred Stanke. Here are the correct image and caption aswell as the corresponding text fromthe article. The staff of EDFA magazine regrets any confusion caused by this error. “The sMIM-Cmeasured on various bulk dielectrics shows a clear linear relationship between sMIM-C and the log of the permittivity. [4,5,16] The red squares shown in Fig. 2 are from a model that originates with a finite-element calculation of the tip-sample admittance for the conical geometry of the sMIM probe. The origins of the log( ε ) dependence can be seen in analytical models for spherically terminated conical tips above and in contact with linear materials, documenting the origin of the log dependence published by other researchers. [17] ” ERRATUM FOR NOVEMBER ISSUE'S sMIM ARTICLE Fig. 2 Graph of the numericallymodeled admittance versus the dielectric value (in red) with the experimentally measured sMIM versus the dielectric value (in blue) from a group of bulk crystal dielectric samples
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy