edfas.org 11 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 26 NO. 4 37. P. Thibault, et al.: “High-Resolution Scanning X-Ray Diffraction Microscopy,” Science, 2008, 321(5887), p. 379-382. 38. E.H.R. Tsai, et al.: “X-Ray Ptychography with Extended Depth of Field,” Opt. Express, 2016, 24(25), p. 29089-29108. 39. T.M. Godden, et al.: “Ptychographic Microscope for ThreeDimensional Imaging,” Opt. Express, 2014, 22(10), p. 12513-12523. 40. E. Kirkland: “Computation in Electron Microscopy,” Acta Crystallographica Section A, 2016, 72(1), p. 1-27. 41. S. Gao, et al.: “Electron Ptychographic Microscopy for ThreeDimensional Imaging,” Nature Communications, 2017, 8(1), p. 163. 42. H. Sha, et al.: “Sub-Nanometer-Scale Mapping of Crystal Orientation and Depth-Dependent Structure of Dislocation Cores in SrTiO3,” Nature Communications, 2023, 14(1), p. 162. 43. P.A. Midgley and M. Weyland: “3D Electron Microscopy in the Physical Sciences: The Development of Z-Contrast and EFTEM Tomography,” Ultramicroscopy, 2003, 96(3), p. 413-431. 44. W. Van den Broek, et al.: “Correction of Non-Linear Thickness Effects in HAADF STEM Electron Tomography,” Ultramicroscopy, 2012, 116, p. 8-12. 45. D.J. Chang, et al.: “Ptychographic Atomic Electron Tomography: Towards Three-Dimensional Imaging of Individual Light Atoms in Materials,” Physical Review B, 2020, 102(17), p. 174101. 46. P.M. Pelz, et al.: “Solving Complex Nanostructures with Ptychographic Atomic Electron Tomography,” Nature Communications, 2023, 14(1), p. 7906. 47. Z. Ding, et al.: “Three-Dimensional Electron Ptychography of Organic– Inorganic Hybrid Nanostructures,” Nature Communications, 2022, 13(1), p. 4787. 48. J. Lee, et al.: “Multislice Electron Tomography using FourDimensional Scanning Transmission Electron Microscopy,” Physical Review Applied, 2023, 19(5), p. 054062. 49. R. Hovden, et al.: “Breaking the Crowther Limit: Combining Depth-Sectioning and Tilt Tomography for High-Resolution, WideField 3D Reconstructions,” Ultramicroscopy, 2014, 140, p. 26-31. 50. M.G.C. Andrey Romanov, et al.: “High-Resolution 3D Phase-Contrast Imaging Beyond the Depth of Field Limit via Ptychographic MultiSlice Electron Tomography,” arXiv, doi.org/10.48550/arXiv.2311. 02580. 51. C. Hofer and T.J. Pennycook: “Reliable Phase Quantification in Focused Probe Electron Ptychography of Thin Materials,” Ultramicroscopy, 2023, 254, p. 113829. 52. H. Yang, et al.: “Enhanced Phase Contrast Transfer using Ptychography Combined with a Pre-Specimen Phase Plate in a Scanning Transmission Electron Microscope,” Ultramicroscopy, 2016, 171, p. 117-125. 53. S. Cao, A.M. Maiden, and J.M. Rodenburg: “Image Feature Delocalization in Defocused Probe Electron Ptychography,” Ultramicroscopy, 2018, 187, p. 71-83. 54. M.J. Humphry, et al.: “Ptychographic Electron Microscopy using High-Angle Dark-Field Scattering for Sub-Nanometre Resolution Imaging,” Nature Communications, 2012, 3(1), p. 730. 55. M.C. Cao, et al.: “Automatic Parameter Selection for Electron Ptychography via Bayesian Optimization,” Scientific Reports, 2022, 12(1), p. 12284. 56. N. Dellby, et al.: “Progress in Aberration-Corrected Scanning Transmission Electron Microscopy,” Journal of Electron Microscopy, 2001, 50(3), p. 177-185. 57. H. Sawada, et al.: “Atomic-Resolution STEM Imaging of Graphene at Low Voltage of 30 kV with Resolution Enhancement by using Large Convergence Angle,” Physical Review Letters, 2015, 114(16), p. 166102. 58. M. Linck, et al.: “Chromatic Aberration Correction for Atomic Resolution TEM Imaging from 20 to 80 kV,” Physical Review Letters, 2016, 117(7), p. 076101. ABOUT THE AUTHORS Aaron C. Johnston-Peck is a materials research engineer at the National Institute of Standards and Technology where he characterizes materials using various electron microscopy techniques. Prior to NIST, he worked as a postdoctoral fellow at Brookhaven National Laboratory and received his Ph.D. in materials science and engineering from North Carolina State University. He has contributed to 50 peer reviewed publications. Andrew A. Herzing is a materials research engineer at the National Institute of Standards and Technology where he develops material characterization techniques with a particular interest in tomography and 4D-STEM. He received his Ph.D. in material science and engineering from Lehigh University in 2007 and is currently serving as the president-elect of the Microanalysis Society. Advertise in Electronic Device Failure Analysis magazine! For information about advertising in Electronic Device Failure Analysis: KJ Johanns, Business Development Manager 440.671.3851, kj.johanns@asminternational.org Current rate card may be viewed online at asminternational.org/advertise.
RkJQdWJsaXNoZXIy MTYyMzk3NQ==