August_EDFA_Digital
edfas.org 15 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 3 the number of yearly ERAI reports for the 16 most-coun- terfeited manufacturer parts (in 2017), and notes there are 373 additional manufacturers with suspect counter- feit parts reported in this six-year span. It is unclear why Xilinx’s parts are so popular with counterfeiters, but it’s likely a combination of high price, high design turnover (increased obsolescence), and the fact that Xilinx FPGAs and other programmable parts are extremely popular in complex, critical systems. The data to the right of the figure, in red, shows the rankings (from most counterfeited to least) for 2017 vs. 2016. Note that the three biggestmovers up the ladder (an undesirable trend) areAltera, Vishay/Siliconix, andMurata. Altera trails only Xilinx in the manufacture of complex programmable parts. Vishay/Siliconix manufactures a wide range of electronic parts, but most of the reported suspect parts are not ICs but simpler parts such as diodes, optoelectronics, resistors, and inductors. Murata is rising on this list primarily due to increased reporting of ceramic capacitors. SUMMARY AND PATH FORWARD Counterfeit electronic parts continue to be reported at a high volume, although this trend may be decreasing somewhat. Counterfeiters continue to fake complex parts such as microprocessors and memory, and in particular, Xilinx parts. Industrial and military temperature range parts are the most popular. In addition, counterfeiters appear to be expanding into low complexity discrete parts like capacitors. These small parts are o¨en easier to counterfeit because they may be unmarked and data sheet characteristics may be diicult to verify. Tominimize the risk of counterfeit parts, it is important topurchase all electronic parts fromthe authorized supply chain whenever possible. It is also critical to perform adequate authentication testing on electronic parts purchased from unauthorized suppliers. SAE standards such as AS5553, AS6081, and AS6171 can provide guid- ance. Visual inspection is still themost common detection method for counterfeit electronic parts, but no single test is 100 percent eective. Additional inspections and tests that use solvents, x-ray, scanning electron microscopy, electrical test, and other methods should be part of a robust authentication process. The industry needs to look toward expanding the avail- able suite of inspections and tests. For example, testing of capacitors might need to include temperature testing or voltage verification. We should aggressively pursue novel authenticationmethods suchas “side channel” elec- trical testing as a means to identify variations within a part lot without having toperforma complete functional test. Only by continuing to search for improved methods can we hope to stay ahead of advancing counterfeit- ing skills. Fig. 5 Suspect counterfeit reports by manufacturer. Number of reports
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy