May_EDFA_Digital
edfas.org 23 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 2 and Benefits of Product-Like SRAM in Technology Development,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2011, p. 362. 3. Z.G. Song, J.Y. Dai, S. Ansari, C.K. Oh, and S. Redkar: “Front-end Processing Defect Localization by Contact-level Passive Voltage Contrast Technique and Root Cause Analysis,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2002, p. 97. 4. J.C. Lee and J.H. Chuang: “Fault Localization in Contact Level by Using Conductive Atomic Force Microscopy,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2003, p. 413. 5. C-MShen, T-C Chuang, S-C Lin, L-FWen, and C-MHuang: “Combining theNano-probingTechniquewithMathematics toModel and Identify Non-Visual Failures,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2007, p. 214. 6. N. Khurana and C. L. Chiang: “Analysis of Product Hot Electron Problem by Gated Emission Microscopy,” IEEE 24th Ann. Int. Reliab. Phys. Symp. (IRPS), 1986, p. 189. 7. J.C.H. Phang, D.S.H. Chan, S.L. Tan, W.B. Len, K.H. Yim, L.S. Koh, C.M. Chua, and L.J. Balk: “A Review of Near Infrared Photon Emission Microscopy andSpectroscopy,” Proc.Int.Symp.Phys.Fail.Anal.Integr. Circuits (IPFA), 2005, p.275. 8. J.C.H. Phang, D.H Chan, M. Palaniappanl, J.M. Chin, B. Davis, M. Bruce, J. Wilcox, G. Gilfeather, C.M. Chua, L.S. Koh, H.Y. Ng, and S.H. Tan: “Review of Laser Induced Techniques for Microelectronic Failure Analysis,” Proc. Int. Symp. Phys. Fail. Anal. Integr. Circuits (IPFA), 2004, p. 255. 9. E.I. Cole, Jr., P. Tangyunyong, andD.L. Barton: “Backside Localization of Open and Shorted IC Interconnections,” IEEE 36th Ann. Int. Reliab. Phys. Symp. (IRPS), 1998, p. 129. 10. E.I. Cole, P. Tangyunyong, D.A. Benson, and D.L. Barton: “TIVA and SEI Developments for Enhanced Front andBackside Interconnection Failure Analysis,” IEEE 10th Ann. European Symp. Reliab. ElectronDev., Fail. Phys. Anal. (ESREF), 1999, p. 991. 11. K. Nikawa and S. Inoue: “New Laser Beam Heating Methods Applicable to Fault Localization and Defect Detection in VLSI Devices,” IEEE 34th Ann. Int. Reliab. Phys. Symp. (IRPS), 1996, p. 346. 12. J. Sylvestri and P. McGinnis, “Laser Induced Critical Parameter Analysis of CMOS Devices,” U.S. Patent # US 7,038,474 B2, May 2006. 13. L. Safran, J. Sylvestri, D. Albert, Z.G. Song, andP. McGinnis: “Advanced Fault Localization through the Use of Tester Based Diagnostics with LVI, LVP, CPA and PEM,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2013, p.313. 14. Y.S. Ng.T. Lundquist, D. Skvortsov, J. Liao, S. Kasapi, and H. Marks: “Laser Voltage Imaging: ANewPerspective of Laser Voltage Probing,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2010, p.5. 15. T. Parrassin, G. Celi, S. Dudit, M. Vallet, A. Reverdy, P. Pedu, and D. Lewis: “Laser Voltage Imaging and Its Derivatives, Efficient Techniques to Address Defect On 28 nmTechnology,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2013, p. 306. 16. H.K. Heinrich, D.M. Bloom, B.R. Hemenway, K. McGroddy, and U. Keller: “Noninvasive Optical Sheet Charge Density Probe for Silicon IntegratedCircuits,” IEEETrans.ElectronDevices, 1987, 33 (11), p. 1860. 17. M. Paniccia, T. Eiles, V.R.M. Rao, andW.M. Yee: “Novel Optical Probing Technique for FlipChip Packaged Microprocessors,” Proc. Int. Test Conf. (ITC), 1998, p. 740. 18. M.R. Bruce, V.J. Bruce, D.H. Eppee, I. Wilcox, E.I. Cole, P. Tangyunyong, and C.F. Hawkins: “Soft Defect Localization (SDL) on ICs,” Proc. Int. Symp. Test. Fail. Anal. (ISTFA), 2002, p. 21. ACKNOWLEDGMENTS The authors would like to thank Thuy Su for her help with physical failure analysis, Christopher Hodge for guid- ancewith LVI/LVP, John Sylvestri (from IBM) for assistance with the CPA analysis, and Manuel Villalobos for his input on TIVA and PEM imaging. REFERENCES 1. S. Naik, F. Agricola, and W. Maly: “Failure Analysis of High Density CMOS SRAMs,” IEEE Des. Test Comput., 1993, 10 (2), p. 13. 2. F. Beaudoin, S. Lucarini, F. Towler, S. Wu, Z. Song, D. Albert, L. Safran, J. Sylvestri, G. Karve, X. Yu, E. Kachir, and N. Jungmann: “Challenges Fig.15 LVI image mapping the clock and data signals for a reference scan chain and failing scan chain. Yellow for clock signal and blue for data signal. Fig. 16 High-magnification LVI image and LVP waveforms collected from points 4, 6, and 8 in register 10.
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy