February_EDFA_Digital

edfas.org 27 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 microstructure, and reliability of assemblies enabled through copper pillar/interposer technology were examined. Both silicon/micro-copper pillar/solder cap/ glass and silicon/micro-copper pillar/solder cap/silicon assemblies with a large number of I/Os were examined in a configuration that allowed monitoring of electri- cal continuity during test. Significant variation in Ag 3 Sn precipitate morphology was observed under nominally identical fabrication conditions. These were correlated with relatively large variations in mechanical behavior, for example, in measured values of shear strength. Large variations in Ag 3 Sn precipitate size and number were also observed with changes in composition and upon aging, as would be expected. Copper pillar assemblies revealed small but continuous solder layers. After failure during ATC, cracks were found to have propagated through these continuous solder layers. Even though the silicon-to- silicon joints had no CTEmismatch, therewere still solder fails. Thus, underfill is recommended for all structures; both silicon-silicon and silicon-glass will benefit. ACKNOWLEDGMENTS The authors gratefully acknowledge funding of this study by Universal Instruments’ Advanced Research in Electronics Assembly Consortium and the active support of its many industry sponsors. The authors also acknowl- edge support fromthe Integrated Electronics Engineering Center at Binghamton University. The authors would like to thank IBM Corporation and Corning Inc. for providing thematerials. The help of Michael Meilunas, to design the test vehicle, and useful comments from Dr. Jim Wilcox, Universal Instruments, were appreciated. REFERENCES 1. T.K. Lee, T.R. Bieler, C.U. Kim, and H. Ma: Fundamentals of Lead-Free Solder Interconnect Technology: From Microstructures to Reliability, Springer, New York, 2015. Fig. 12 Weibull distribution of lifetime for (a) corner joints of non-underfilled assemblies and (b) chain joints of non-underfilled assemblies, high CTE (continued on page 30) (b) (a)

RkJQdWJsaXNoZXIy MjA4MTAy