February_EDFA_Digital
edfas.org 25 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 precipitateswas approximately 10 µm, so the precipitates no longer significantly hindered dislocation movement. In 30-µm-diameter copper pillars, the shear strength of the shear strength of the copper pillar and the solder. Scanning electron microscopy examination of the metal remaining on the pad after shearing (Fig. 8a) and energy- dispersive analysis (Fig. 8b), along with plots of the force versus displacement (Fig. 8c), provided insight on the nature of the failure in the solder joint. If the force-versus- displacement plot indicated ductile failure (Fig. 8c), and the majority of the remaining metal on the pad was tin (Fig. 8b), then the indication was ductile failure in the solder. This was confirmed in the present case by SEM micrograph of a cross section of the shear solder joint (Fig. 8d), which revealed a significant amount of solder remaining on the pad. Solder failure was observed to be ductile for all samples tested, including all compositions, as-reflowed and aged samples, for both pad diameters. Measurements of shear strength were conducted for a variety of copper pillar/solder joints, both as-reflowed and after 1000 h of aging at a temperature of 125 ° C (Fig. 9). Three different solder compositions were studied, with different silver concentrations, and two different copper pillar diameters were examined: 30 and 100 µ m. After aging, the values for shear strength were essentially the same for all samples, with values near 23 MPa. This correlated with the observation that the Ag 3 Sn precipitates had coarsened significantly in all of the samples after aging, leaving few (less than ten) pre- cipitates in a given cross section. The spacing between Fig. 8 Shear strength of solder cap after 1000 h aging. (a) Top view for failure of samplewith pad diameter of 30 µm. (b) Energy- dispersive x-ray analysis to prove the failure type. (c) Force vs. displacement plot for pad diameter of 100 µm. (d) Cross section after failure for sample with pad diameter of 100 µm on silicon chip Fig. 9 Shear strength of solder cap depending on solder composition and pad diameter (solder volume) for pad diameters of (a) 30 µm and (b) 100 µm (b) (a) (b) (a) (d) (c)
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy