February_EDFA_Digital
edfas.org 1 1 ELECTRONIC DEVICE FAILURE ANALYSIS | VOLUME 20 NO. 1 laser stimulation cannot be used. Candidate circuits for failure analysis are chosen because their boundary failing conditions show soft fail behavior versus supply voltage. Only two techniques provide usable results: dynamic laser soft defect localization (SDL) [2] and laser voltage probing (LVP). [3] No signatures were obtained with other tech- niques (emission microscopy, laser frequency imaging). Using a 220 × (2.45 NA) solid immersion lens with an 8 × laser scan magnification through the backside of the silicon, the SDL signature provides very accurate localiza- tion of the failure, highlighting the PMOS of a gate con- trolled by the internal clock. Figure 2 shows the location in a flip-flop for the scan chain failure case, and a similar result is found in the memory failure case. Fig. 1 (a) Schematic of a scan chain used to capture values in the high-speed core logic using the high-frequency internal clock (capture mode) and then shifting the data out of the circuit in serial through the flip-flops using an external low- frequency clock (scan or shift mode). (b) Timing diagram of Ck_FF for several scan/capture sequences Fig. 2 (a) Shmoo plot showing electrical test setup configuration of the test sequence for a scan chain failure leading to SDL in (b). A PMOS gated by the clock is highlighted in a flip-flop. (a) (b) (a) (b)
Made with FlippingBook
RkJQdWJsaXNoZXIy MjA4MTAy